Electronic bistable impulse relay BIS-414 24 V

Electronic bistable impulse relay BIS-414 24 V


Electronic bi-stable pulse relays BIS-414 24V enables the user to actuate lighting or other devices from various locations by means of control buttons in parallel connection.
Single function. Power supply 24 V AC. Maximum load 2 x16 A. On TH-35 mm rail.

The relay have got two switch ON section and enable to switch ON in accordance sequence two circuits of lights or diferent recuiver from many places by pushbuttons connected in parallel. Switching the relay into another cycle phase is made by another current pulse triggered by pressing any bell push connected to the relay.

Relay power is indicated by a green LED U. Sequential relay has two separate outputs: R1 and R2. Contact state (open/closed) is forced sequentially in accordance with a predetermined program. State of contact is switched by a subsequent impulse from the the control key. Switching of R1 and R2 contacts is indicated by the corresponding R1 and R2 red LEDs. In case of a power failure, the contact state is reset. When the supply voltage returns, relay starts with a sequence number 0.



Power of receivers

These data are indicative and will heavily depend on the design of a specific receiver (that is especially important for LED bulbs, energy-saving lamps, electronic transformers and pulse power supply units), switching frequency and operating conditions.


Power supply voltage9├Ě30 V AC/DC
Local controlYES
Maximum AC-1 load current2 x 16 A
The executive elementrelay
Contact configuration2 ├Ś NO/NC
Separation of the contactYES
Resistance to shock currentsNO
Number of channels2
Delay of operation0,1 ├Ě 0,2 s
Control pulse currentless than 1 mA
Cooperation with illuminated buttonsNO
Status memory after power failureNO
Activate on timeNO
Dedicated central control inputsNO
Radio controlNO
terminalscrew terminals 2,5 mm┬▓
Tightening torque0,4 Nm
Power consumption0,7 W
Working temperature-25 ├Ě 50 ┬░C
dimensions1 module (18 mm)
Assemblyon rail 35 mm
Level of securityIP20
Przyciski pod┼Ťwietlane
Z uwagi na niskie napi─Öcie zasilania nie nale┼╝y stosowa─ç przycisków pod┼Ťwietlanych.

Maksymalny pr─ůd obci─ů┼╝enia
Pr─ůd styku podany w danych technicznych jest warto┼Ťci─ů maksymaln─ů i mo┼╝e podlega─ç ograniczeniom – wi─Öcej informacji. Je┼Ťli z przedstawionych informacji wynika, ┼╝e przeka┼║nik w urz─ůdzeniu jest niewystarczaj─ůcy zaleca si─Ö stosowa─ç zewn─Ötrzny element prze┼é─ůczaj─ůcy (np. stycznik) przystosowany do prze┼é─ůczania du┼╝ych pr─ůdów udarowych.

Pami─Ö─ç stanu
Przeka┼║nik nie posiada "pami─Öci" pozycji styku. Oznacza to, ┼╝e po za┼é─ůczeniu zasilania styk przeka┼║nika zawsze pozostanie w stanie wy┼é─ůczonym.