Universal lighting dimmer SCO-815 230 V

Reference: SCO-815, EAN13: 5908312596684

Product description

The universal dimmer allows you to adjust the brightness of the lighting.
Load R, L, C, LED & ESL.

Universal lighting dimmer allows you to adjust the brightness of light following light sources:
- Incandescent lamps, halogen lamps, the main series (resistive load R)
- Lamp powered by a toroidal transformer (inductive load L)
- Lamp powered by an electronic transformer (capacitive load C)
- Compact fluorescent lamps (ESL) with dimming
- Energy-efficient LED lights (LED) with dimming

Functioning
Lighting can be controlled by a number of buttons connected in parallel, located at different points in the room. Activation of the receiver at the last set brightness level occurs after a pulse of current caused by pressing any momentary (bell) button connected to the relay. Short press of a button turns on the lighting. Pressing and holding (above 1 second) changes the brightness level in one direction (brightening or dimming). Each time the button is pressed (more than 1 second), the adjustment is made in the opposite direction.

Attention!
Control input is galvanically isolated from the power supply of dimmer. Ability to connect a separate control voltage different from the power supply. Terminals 7-8-9 are connected and form a single point of N.
SCO-815 can be used with backlighted buttons.

Power supply voltage	230 V AC
Installation	3-wires
The executive element	transistor
State memory	YES
Status memory after power failure	NO
Maximum power of connected bulbs	R/L/C - 500W ; ESL/LED - 100W
Control voltage	8÷230V AC/DC
Application	incandescent lighting, halogen lighting, LED (dimmable), fluorescent lamps (dimmable)
Control the load	switching on or off at 0 (universal loads)
Terminal	pluggable terminal blocks 2,5 mm²
Tightening torque	0,4 Nm
Power consumption	0,1 W
Working temperature	-25 ÷ 50 °C
Dimensions	1 module (18 mm)
Assembly	on rail 35 mm
Ingress Protection Marking	IP20