The receiver is actuated by means of a current pulse triggered by pushing any bell push connected to the relay. The receiver is deactivated by another pulse or after a preset time.
The relay does not ÔÇťmemorizeÔÇŁ the position of the relay contact, i.e. in case of supply voltage decay and the subsequent return of supply voltage, the relay contact will be set in the off position. Such a solution prevents the automatic actuation of the receivers controlled that might occur without proper supervision after a long-lasting decay of supply voltage.
The BIS-411Mi (230V versions) compatible with bell pushes equipped with fluorescent lamps.
The above data are indicative and will depend to a large extent on the design of a specific receiver (especially for LED bulbs, energy saving lamps, electronic transformers and pulse power supplies), switching frequency and working conditions.
|Power supply voltage||165├Ě265 V AC|
|Maximum AC-1 load current||16 A (160 A/20 ms)|
|The executive element||relay|
|Contact configuration||1 ├Ś NO|
|Separation of the contact||YES|
|Resistance to shock currents||YES|
|Number of channels||1|
|Delay of operation||0,1 ├Ě 0,2 s|
|Control pulse current||less than 5 mA|
|Cooperation with illuminated buttons||YES|
|Status memory after power failure||YES|
|Activate on time||NO|
|Dedicated central control inputs||NO|
|terminal||screw terminals 2,5 mm┬▓|
|Tightening torque||0,4 Nm|
|Power consumption||0,7 W|
|Working temperature||-25 ├Ě 50 ┬░C|
|dimensions||1 module (18 mm)|
|Assembly||on rail 35 mm|
|Level of security||IP20|