Polski
English
PA-01U analogue relay
An analogue relay with a 0–10 V voltage input and a relay output.
Voltage input range: 0–10 V.
Output: 1 × NO/NC relay.
4 operating modes.
Galvanically isolated measurement input.
PA-01U analogue relay, 0–10 V voltage input
Why choose the PA-01U?
The PA-01U measures an analogue voltage signal of 0–10 V and, based on its value and the selected operating mode, controls the relay output.
What does this mean in practice?
- The voltage input operates within the range 0–10 V.
- The actuator is a relay with a 1 × NO/NC contact configuration.
- The device offers 4 operating modes.
- The measurement input is galvanically isolated from the power supply and the contact circuit.
- The output state depends on the measured voltage value and the selected operating mode.
Note
To confirm a new operating mode, the power must be switched off and then back on again.
- Power supply voltage
- 9÷30 V DC
- Maximum AC-1 load current
- 8 A
- Measurement error
- 1%
- The executive element
- relay
- Contact configuration
- 1 × NO/NC
- Separation of the contact
- YES
- Power consumption (max)
- 100 mA
- Voltage input resistance
- 69 kΩ ± 0,1 %
- Range of input signals
- 0÷10 V
- Hysteresis setting range
- 0÷2,5 V
- Measurement resolution
- 2,5 mV
- Hysteresis in "window" mode
- 100 mV
- Terminal
- pluggable terminal blocks 1,5 mm²
- Tightening torque
- 0,5 Nm
- Working temperature
- -25 ÷ 50 °C
- Dimensions
- 1 module (18 mm)
- Assembly
- on rail 35 mm
- Ingress Protection Marking
- IP20
Connection diagram
16 other products in the same category
An analogue relay with a 0–10 V voltage input and a relay output.
Voltage input range: 0–10 V.
Output: 1 × NO/NC relay.
4 operating modes.
Galvanically isolated measurement input.